Casio Edifice ECW-M300EDB-1AER инструкция

Casio Edifice ECW-M300EDB-1AER
8.1 · 5
PDF инструкция
 · 7 страниц(ы)
английский
инструкцияCasio Edifice ECW-M300EDB-1AER

Operation Guide 5117

5
Recovery TimesThe table below shows the amount exposure that is required to take the battery fromone level to the next.Approximate Exposure TimeLevel 5 Level 4 Level 3 Level 2 Level 12 hours 22 hours 6 hours7 hours 82 hours 22 hours10 hours 133 hours 36 hours113 hours - - - - - - - - - - - - - - - -Exposure Level(Brightness)Outdoor Sunlight(50,000 lux)Sunlight Through aWindow (10,000 lux)Daylight Through aWindow on a CloudyDay (5,000 lux)Indoor FluorescentLighting (500 lux)
The above exposure time values are all for reference only. Actual required exposuretimes depend on lighting conditions.

Timekeeping

You can adjust the Home City time and date in the Timekeeping Mode manually. Youalso can simultaneously display the current time in one other time zone, by specifyinga Dual Time City.
For information about selecting a Dual Time City, see “To specify the Dual Time City”.
Pressing D in the Timekeeping Mode will cycle the lower display between the
screens shown below.
D
D
Home City date Home City time Dual Time
D
Read This Before You Set the Time and Date!
This watch is preset with a number of city codes, each of which represents the timezone where that city is located. When setting the time, it is important that you firstselect the correct city code for your Home City (the city where you normally use thewatch). If your location is not included in the preset city codes, select the preset citycode that is in the same time zone as your location.Note that all of the times for the World Time city codes and Dual Time City aredisplayed in accordance with the time and date settings you configure for theTimekeeping Mode.To set the time and date manually1. In the Timekeeping Mode, hold down A for about fiveseconds until the left dial hand points to T1 and the citycode flashes on the upper display. This is the settingscreen.
2. Use D and B to select the city code you want.
Make sure you select your Home City code beforechanging any other setting.For full information on city codes, see the “City CodeTable”.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
3. Press C to move the flashing in the sequence shown below to select the other
settings.

Seconds

12/24-Hour

Format

Hour

Minutes

DST

Month

Year

City Code

DayPower Saving

4. When the timekeeping setting you want to change is flashing, use D or B to
change it as described below.Change the city codeCycle between Auto DST ( ),Daylight Saving Time () andStandard Time (
).
Use D (east) and B(west).Press D.
To do this: Do this:Screen:
5. Press A twice to exit the setting screen.For details about the Daylight Saving Time setting, see “To change the DaylightSaving Time (summer time) setting”. For information about Power Saving, see “Toturn Power Saving on and off”.Toggle between 12-hour ( ) and24-hour ( ) timekeepingReset the seconds to Change the hour and minutesChange the year, month, or dayToggle between Power Saving on
(
) and off ( )Press D.Press D.
Use D (+) and B (–).
Press D.
Auto DST (AvtA) can be selected only while
LIS
,
LON
,
MAD
,
PAR
,
ROM
,
BER
,
STO
,
ATH
,
MOW
,
TPE
,
SEL
,
TYO
,
HNL
,
ANC
,
YVR
,
LAX
,
YEA
,
DEN
,
MEX
,
CHI
,
MIA
,
YTO
,
NYC
,
YHZ
,
or
YYT
is selected as the Home City code. For moreinformation, see “Daylight Saving Time (DST)” below.The day of the week is displayed automatically in accordance with the date (year,month, and day) settings.
Daylight Saving Time (DST)
Daylight Saving Time (summer time) advances the time setting by one hour fromStandard Time. Remember that not all countries or even local areas use DaylightSaving Time.The time calibration signals transmitted from Mainflingen (Germany), Anthorn(England), or Fort Collins (the United States) include both Standard Time and DSTdata. When the Auto DST setting is turned on, the watch switches between StandardTime and DST (summer time) automatically in accordance with the signals.Though the time calibration signals transmitted by the Fukushima and Fukuoka/Saga, Japan transmitters include summer time data, summer time currently is notimplemented in Japan (as of 2009).The default DST setting is Auto DST () whenever you select LIS
,
LON
,
MAD
,
PAR
,
ROM
,
BER
,
STO
,
ATH
,
MOW
,
TYO
,
ANC
,
YVR
,
LAX
,
YEA
,
DEN
,
MEX
,
CHI
,
MIA
,
YTO
,
NYC
,
YHZ
,
or
YYT
as your Home City code.If you experience problems receiving the time calibration signal in your area, itprobably is best to switch between Standard Time and Daylight Saving Time(summer time) manually.To change the Daylight Saving Time (summer time) setting1. In the Timekeeping Mode, hold down A for about fiveseconds until the left dial hand points to T1 and the citycode flashes on the upper display. This is the settingscreen.2. Press C and the DST setting screen appears.3. Use D to cycle through the DST settings in thesequence shown below.

Auto DST ( ) DST off ( ) DST on ( )

4. When the setting you want is selected, press A twice to exit the setting screen.
The DST indicator appears to indicate that Daylight Saving Time is turned on.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
DST indicator
Dual Time
Dual Time lets you display the current time in another time zone called your “DualTime City”, in addition your Home City’s current time. This feature is very handy forbusiness professionals and others who need to keep track of the current time in twodifferent time zones. For information about how to display the current time in the Dual Time City in thelower display, see “Timekeeping”.To specify the Dual Time City1. In the Timekeeping Mode, hold down A for about fiveseconds until the left dial hand points to T1 and the citycode flashes on the upper display.
2. Press A again. The left dial hand will move to T2 and
the current Dual Time City code will start to flash on theupper display. This is the Dual Time City selectionscreen.
3. Use D (eastward) and B (westward) to scroll through
the available city codes. See the “City Code Table” for information about citycodes.4. Press A to exit the setting screen.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
Left dial hand

Hand Home Position Correction

The hour and minute hands of the watch can be thrown off by exposure to strongmagnetism or impact. You can perform correction of the hour and minute hand home positions manually.To adjust the home positions manually1. In the Timekeeping Mode, hold down D for about threeseconds, until H-SET appears on the upper display.The dial hands are in their correct home positionswhen the left dial hand moves to C (CHG) and the
stopwatch hand moves to 60. If they don’t, use B to
adjust the left dial hand position and D to adjust thestopwatch hand position.2. After confirming that both dial hands are in their correcthome positions, press C.This will change to hour hand and minute hand homeposition manual correction.Correct dial handpositions
l
l
l
l
l
l
l
l
l
l
l
l
l
l
The hour and minute hands are in their correct homepositions if they are pointing to 12 o’clock. If they arenot, use D (+) and B (–) to adjust their positions asrequired.
Pressing C here will return to the setting at the
beginning of step 2.3. After everything is the way you want, press A to returnto the Timekeeping Mode.After you complete the home position adjustmentprocedure, place the watch in a location that allowsgood time calibration signal reception, and then amanual receive operation. See “To perform manualreceive” for more information.Correct hour andminute handpositions
l
l
l
l
l
l
l
l
l
l
l
l
l
l
12-hour and 24-hour timekeeping
With the 12-hour format, the PM indicator appears to the left of the hour digits for
times in the range of noon to 11:59 p.m. and no indicator appears to the left of thehour digits for times in the range of midnight to 11:59 a.m.With the 24-hour format, times are displayed in the range of 0:00 to 23:59, withoutany indicator.The 12-hour/24-hour timekeeping format you select in the Timekeeping Mode isapplied in all other modes.

Инструкция

Посмотреть инструкция для Casio Edifice ECW-M300EDB-1AER бесплатно. Руководство относится к категории Часы, 5 человек(а) дали ему среднюю оценку 8.1. Руководство доступно на следующих языках: английский. У вас есть вопрос о Casio Edifice ECW-M300EDB-1AER или вам нужна помощь? Задайте свой вопрос здесь

Нужна помощь?

У вас есть вопрос о Casio Edifice ECW-M300EDB-1AER а ответа нет в руководстве? Задайте свой вопрос здесь Дай исчерпывающее описание проблемы и четко задайте свой вопрос. Чем детальнее описание проблемы или вопроса, тем легче будет другим пользователям Casio Edifice ECW-M300EDB-1AER предоставить вам исчерпывающий ответ.

Количество вопросов: 0

Технические характеристики Casio Edifice ECW-M300EDB-1AER

Ниже вы найдете технические характеристики изделия и руководства по эксплуатации Casio Edifice ECW-M300EDB-1AER.

Главная
Бренд Casio
Модель Edifice ECW-M300EDB-1AER
Изделие Часы
Язык английский
Тип файла Руководство пользователя (PDF)

Часто задаваемые вопросы

Не можете найти ответ на свой вопрос в руководстве? Вы можете найти ответ на свой вопрос ниже, в разделе часто задаваемых вопросов о Casio Edifice ECW-M300EDB-1AER.

Не нашли свой вопрос? Задайте свой вопрос здесь

Нет результатов