WNER ’ S
THERP ROOF IR CAMERA
AL IR C AMERA SERIES
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to
alert the user to the presence of un-insulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance-(servicing) instructions in the literature
accompanying the appliance.
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM OF THE SYSTEM.
"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR
Explanation of two Symbols
Design and specifications are subject to change without notice.
The image does not appear on the
The image on the screen is dim.
The camera does not work properly,
the surface of the camera case is
hot, and a black line appears on the
The screen blinks a lot.
Check the power source for the monitor
and camera and ensure that the voltage
and polarity are properly connected and
being supplied correctly.
Check if the lens is stained. If dirty,
clean the lens with a soft, clean cloth.
Adjust the Back Focus of the lens again.
Check if you have connected the camera
to a proper power source and If there is
no problem with the power, turn the unit
off immediately and seek assistance
from our Customer Service department.
Check if the camera is pointed toward
the sun or a fluorescent lamp.
Adjust the angle or location of the camera
if too much light is coming into the screen.
If you have trouble operating your camera, refer to the following.
If the guidelines do not enable you to solve the problem, contact
an authorized technician.
TO REDUCE THE RISK OF
Changes or modifications not expressly approved by the manufacturer
void the user's authority to operate the equipment.
When this camera is installed near equipment, like a wireless communication
device that emits a strong electromagnetic field, some irregularity such as
on the monitor screen may happen.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions : (1)This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.These limits
are designed to provide reasonable protection against harmful interference
in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and use in accordance with the instructions, may cause
harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause interference, in which case the user
will be required to correct the interference at his own expense.
HIGH RESOLUTION NORMAL RESOLUTION
0.05 Lux (High) , 0.01 Lux (Normal) , 0 Lux (IR LED On)
752(H)x582(V) 510(H)x492(V) 500(H)x582(V)
NTSC - 1/60 ~ 1/120,000 sec
PAL - 1/50 ~ 1/120,000 sec
10V DC ~ 15V DC (Recomendation 12V DC ± 0.5V DC)
0.5A (Max 6.0W)
78.0 × 150.0mm
IR LED 36EA
Bulit-in Fixed Lens, f=6mm (Option:12mm)
1/3” High Sensitivity CCD
15.734 KHz 15.625 KHz
IR LED Visible Range
C to +50
C / 30% to 80% RH
C to +60
C / 20% to 90% RH