Tascam CD-6010 инструкция

CD-6010

Printed in China

Functions added in firmware

V1.30

End check function

An end check function has been added that allows you to

check the ends of tracks. This is useful when you want to

check how a track ends.

Setting the amount of time checked

Set how many seconds before the end of the track

playback should start with this function. Use the “25

END-C” menu item to set the number of seconds before

the end of the track.

Setting range: 5 (default) – 35 (in 5 second intervals)

Using this function

To start end check playback of the currently selected track

(for the number of seconds set above), during playback or

ENTER button on the remote control.

After playback completes, the unit returns to the call

point (the point when playback last started) and pauses

playback.

The end check function cannot be used with data CDs.

During A-B repeat playback, end check playback will

start the set number of seconds before the B point,

and the unit will pause at the A point when playback

completes.

Time search function

A time search function has been added that enables

locating to a designated time from the start of a track.

Setting the time search function

Use the “26 NUM-B” menu item to set the time search

function.

Options

TR (default): The time search function is disabled. Press

a number button to directly select a track.

TI: The time search function is enabled. Press a number

button to activate time search mode. The input

position is shown with a blinking “_” (underbar).

Display during time search mode

Using this function

When time search mode is active, use the number buttons

on the main unit or remote control to input minutes,

seconds and frames (two digits each). When input is

complete, the unit locates to the designated time. After

locating, the unit will pause if it had been stopped or

paused before or it will continue playback if it had been

playing before.

The time search function cannot be used with data

The time search function cannot be used when the cue

mode or ash start function is enabled.

When the time search function is set to “TI”, the

number buttons on the main unit and the remote

control cannot be used to select tracks.

Press the CLEAR button on the main unit or the remote

control to clear an input time.

If the “17 FRAME” menu item is set to “OFF”, only

minutes and seconds can be input (frame input is not

possible).